Search results

why is the output shaft on the range rover auto transmission fine splines where the output shaft of the discovery auto transmission is course splines? wanted to replace a borg warner tcase for a lt230 and the tcase input splines are different! course for lt230 and fine spline for borg warner!

anybody swap a complete gems 4.0 into an engineless 94 disco? the whole works, including wiring harness and engine ecu? I do not have a 3.9 to swap parts with! the disco is complete other than the missing motor.

Looking for a rear drive shaft with u-joints for a LWB 1995 (108") RR.....Pat

lets call it Jim!

check to make sure the axel vent is clear!

normal to flash one time

check to see if PO removed amp from under seat.

hc your PM box is full....

I rebuilt my seat base (very corroded) to fir the disco seats...

hc I PM you....

got a radio amp?

How about a radio amp?

Ugh forgot to add "rear seat" I have 2 disco seats in front....

Anyone installed a RRC seat in a 109? Tried the search to no avail....Pat

Put in a set of RN 360lb inch springs....all good now!

Blueboy: It does start with 34300456A

Anyone have suggestions on what springs I should install on my 109 hybrid? It is a 67 IIA 109 5 door that I put on a 1992 RRC chassis lengthened to 108". It has the RRC springs on the back and it bottoms out with 8 guys in it. Thanks....Pat

Is there different VSS units to match different tire sizes? I installed 255X85X16 tires and speedo and shiftpoints need adjusting.

My 109 hybrid has a 1992 RR chassis and drivetrain. I installed 255X86X16 tires and the speedometer and shiftpoints need adjusting. Does rover make different VSS for the defender speedometers to match their taller tires? ....Pat