Search results

So what does that have to do with my wtb ad?

I need a good brake line for my 04 D2. It is the hard line that runs from the abs modulator to the front left wheel well and connects to the soft line running to the caliper. I just need the hard line, not the soft line. Mine is locked up at the junction where the hard and soft lines meet and...

Need a set of new or damn near perfect motor mounts shipped to 87109. Let me know what you have. Thanks!

I have a tan set of jump seats out of my 04 D2. Seats only, great condition. One of the plastic horn shaped levers has cracked off on the drivers side one, but from what I can tell this is normal. I have just used my hand to release it since it cracked. Email me for pics if interested. Local...

MODs if you would be so kind as to move this to the HS part department. Thanks.

I have a tan set of jump seats out of my 04 D2. Seats only, great condition. One of the plastic horn shaped levers has cracked off on the drivers side one, but from what I can tell this is normal. I have just used my hand to release it since it cracked. Email me for pics if interested. Local...

Im pretty sure they have never been replaced. I should have done it last year when I dropped the new motor in but for some reason I said fuck it.

Looking for one of those round 7 pin land rover to 4 pin flat trailer adapters. Let me know what you got. Thanks!

Can someone give me a reliable way to tell whether my engine mounts are toast? Thanks.

Mine idles at 665 +/- 10 rpm, SG2 shows my temp at idle being 206F at the highest, normal for me is 198-206 at idle.

I pulled the jumps seats out of my 04 d2 last week because I have never used them and they rattle a stupid amount. Now I have two sopts in the cargo area that fit my jerry can water jugs perfectly. Has anyone put cans there before and come up with a solid mounting or strapping solution? Its kind...

Hell, I'll do $250 shipped to 87109, paypal immediately as well.

I did not replace the rings. I pulled the injectors and thats when I noticed the deal with the little orange disk retainer things. I also had a brain fart and only got 8 new o rings. So... I put them back in and left them alone. This all happened while I was replacing my valley gasket as well...

Drove the 2004 D2 to work today. Turned it on and it was idling not rough, but certainly not normal and kind of had a shimmy to it as I watched it. Drove fine on the road at speed, but while idling I could tell something was awry. Drove the 40 miles (somehow managing to burn 1/4 tank of gas) to...

I need to test both of my upstreams. Which wire is the signal out wire? (ie: which one of the four do I need to tap into to check the output voltage to see if the sensor is bad or not?)

Last week I re-did my valley gasket. 1- I was bored and 2- needed to retighten my rear gasket holder-downer thingy. While I was in there, I puller the fuel rail out and inspected my injectors. I had new o-rings on hand to replace if needed. I noticed a couple of things. First, almost all of my...

I need two of them, intact in good condition without the tit broken off. Let me know with shipping to 87109. Thanks! Lance

I have got 800 ish 9mm subsonics laying around. Thought I would post them up here to maybe trade for some D2 parts before I hawk them on gun broker. I can do cash up or down. In the market for: set of 5 steelies sd-type rack hella 4000 fogs dog guard cargo separator thing sliders rear +3"...

Pm'ed. Thanks!

Incoming pm. Thanks!