Search results

BCU is not sending a ground signal preventing the starter from actuating. Other than replacing the BCU ($$$s) one suggestion was to insert a push button for the ground and use the button in addtiton to the key to start the truck. Has anyone used or seen this done? 01 Disco II with 87K

Need a front, driver side, window regulator and motor for my 01 Disco II. Anyone have one in a parts truck?

Need a front, driver side, window regulator and motor for my 01 Disco II. Anyone have one in a parts truck?

Thought this might be helpfull. The hood release latch on my 01 Disco was frozen. The cable was still good, pulled on it from inside the truck w/o luck and w/o pulling the wire through. Tried various methods described here and other boards w/o luck, Finelly was abe open the hood enough to get...

Sorry for the duplicate.

Yesterday I replaced the right front locking mechanism on 01 Disco. Everything worked fine ie: both interior and exterior doors handles unlatch and open the door. Problem is that after I reinstalled the panel and closed the door neither handle works. It will lock/unlock with the remote and the...

Going to be in Springfiled for the Thanksgiving weekend. Figure SMORR is close and want to check out the park. Rather not wheel alone in a new spot, would anyone care to join me. It be nice to have someone who was familuar with the place to show me around. Either Fri. or Sat. are good. Frank...

Need a pair of engine mounts for my 01 Disco II. Anyone got a set lying around (Will ?)

Need one Steel Wheel Center Cap - for a DII

Going to be in the Republic/Springfield Mo. area this Tuesday, Wednesday (7/13 ?14) and want to do some trail runs. My mother-in-law (87 yrs young) will be in the Disco so I?ll have to keep it fairly mild. I was planning on heading over to SMORR and running the easy trails, but it looks like...

Available now as a parts truck see below. 1998 DI , 105K, blown head gasket, trans slips and one leaking CV. Pretty much everything that can be taken off is up for sale EXCEPT the Rack, ladder, CDL linkage and two spot lights. I'd prefer local sale for any large parts and will accept PayPal...

Just replaced my expired 1998 DI with a 2001 DII. Blk/tan SE, 40,454mi. 2"-2 1/2" lift, steel wheels, 265x75 MTRs and very very clean (won't that be a change for me) . Going to transfer my rack and sliders (both DII) , PC mount etc. over the weekend. Haven't verified the CDL nipple is on the...

Reading code P1185 (Open O2 Heater Circuit) on my 98 Disco. Problem is can?t seem to find any reference as to which of the 4 sensors is bad. Any way to determine which one is the problem?

I know I should know this but my mind is not working today. The Swivel ball on a DI is at the outer end of the shaft at the wheel assembly correct. NEVER MIND My brain started to function again

http://www.speedtv.com/articles/automotive/newmodels/42095/

Ever get made when attempting to take off a Rover lug nut. Well here is the way NOT do do it.. http://www.msnbc.msn.com/id/21758302/

Some photos of the Tahoe that ran into me and the car I was pushed into. Disco damage: Bent the rear bumper and broke the bumper lights, bent the braces for the front brush bar.

Check the Hold You Breath segment toward the end of the video. Wonder if this could work on a Rover?? Be great for clearing fallen trees ;) http://www.youtube.com/watch?v=eSi6J-QK1lw

I need to get dirty, anyone care to join me at the Badlands in Attica Indiana on Sat. 9/1

Will a DI SD roof rack fit a DII? I know a DII rack will fit a DI but not sure of the reverse. Someone told me the DII is wider and willl not fit.