I bought this http://cgi.ebay.com/ebaymotors/ws/eB...m=190338113751 to run as an in-cab control for my warn xd9000. The question I have is how did those of you who have done this wire the arrow switches for spooling in and out? I have a 5 wire remote.
The arrow switches (X210,X211 in rave) are basically glorified SPST with some lights in them. I was hoping I could just run 12v from the battery (fused of course) to pin 5 on each then wire pin 4 on one to the green "in" wire on the warn and pin 4 on the other switch to the black "out" wire on the warn.
http://www.webejeepin.com/images/Glenns_Jeep/winch-switches.jpg
The thing I cant figure out is what to do with the brown ground wire on the winch since it's switched too in the 5 wire remotes. The schematic shows a DPDT but the arrow keys are SPST. Any ideas how those of you with this set up wired it? Thanks -Rob
The arrow switches (X210,X211 in rave) are basically glorified SPST with some lights in them. I was hoping I could just run 12v from the battery (fused of course) to pin 5 on each then wire pin 4 on one to the green "in" wire on the warn and pin 4 on the other switch to the black "out" wire on the warn.
http://www.webejeepin.com/images/Glenns_Jeep/winch-switches.jpg
The thing I cant figure out is what to do with the brown ground wire on the winch since it's switched too in the 5 wire remotes. The schematic shows a DPDT but the arrow keys are SPST. Any ideas how those of you with this set up wired it? Thanks -Rob