where can i buy cut out fender flares for 95 D1...

[tradin1]

i am looking for a set of cut out flares to install so i can put 34"s on my truck, would like something that is made for the D1, as the D2 fenders do not match up perfectly.

thx in advance

 

[JeffM]

Tried these?

http://www.northeastbritishparts.co... (1) 94 - 99--accessories/7017/WHEEL ARCH KIT

Jeff

 

[tradin1]

dont think those are cut out flares, i was wanting something that u have to cut out the flares including the rear doors.

 

[JohnGA]

People have cut fenders and put on DII flares... the DII flares look really sharp on a DI IMO.

 

[Rocky]

DAP used to stock http://www.dap-inc.com/homeframe.htm what I think you are talking about. Used by ECR on their Discotech http://www.eastcoastrover.com/Discotech/Dtechopenimage.jpg http://www.eastcoastrover.com/Discotech.html

 

[discokid99]

ECR flares...yuck!

just do the D2 flares if you want flares really bad..they look a lot better in my opinion

 

[mightymg]

With my 34s i only had to trim a little, as long as you roll everything once your done cutting, it will all look factory and smooth. ill post some pics of my rolled fenders

 

[mightymg]

heres some pics

 

[FIVESPDDISCO]

lane nice job

 

[mightymg]

thanks all i did is I too electrical tape and marked where I wanted to trim,about 2 inches sbove the stock roll under, then i trimmed on that line, and used a pair of rubber nose channel locks to slowly!!! bob it back under to look stock. then i bent the old mud flap bracket up, and cut the old mounting brace and re welded it to the height I WAnted. Then all you have to do is re drill the whole for the bolt to brace the fender. It only took about an hour its really easy anyone can do it. Good luck.

 

[fastring]

The ECR like flares really open up the wheel well. I installed them on my D1 (see photo gallery - Roger Fastring) and was impressed how much it allowed you to hack off the rear door. I have 33x10.50s now and will be lowering my truck from 4.5" down to 2.5" of lift with the narrow 33s. Getting the RTE arms and upper mount that allows you to push the rear axle back a little helped too. Good luck.

Roger

 

[tradin1]

the flares on dap are the ones that i was looking for, thx.

appreciate all the info.