Factory For Lights Wiring

[FIRE74]

I just installed a ARB bumper and when I removed the stock bumper there was wiring that was in the area of where the factory fog lamps would be,is this for them and if so does the wiring go all the way to the dash so al I have to do is buy the lights and the switch? this is for a 03 Disco S thanks!!

 

[FIRE74]

oops

supposed to say Factory Fog Lights

 

[Bobh82]

The two plugs are indeed for the factory fogs..I just did the same with my S when I put the 03 ARB on. The hardware supplied with the ARB will allow the factory fogs to be mounted in the spaces in the bumper.

Pick up a front fog switch and then go to the dealer and have them activate through testbook the fogs..be prepared to pay big if you buy the fogs through the dealer ($500+)..I picked up both for $150 through private party sale.

Takes 10 min to install. I put seperate switch in for the white lights in the turn signal assembly so I can use them as day runners for hwy trips. I wired the turn sigs through the harness signal wire...

Expect to change out the turn sig bulb (in ARB) to a 10 watt bulb to keep the dash tow signal indicator from flashing.

Good luck

Bob

 

[FIRE74]

Fog Lights

Thanks Bob that helps alot!!! I also removed two of the blank buttons on the left side of the cluster and found them to have wiring connected to them is one of these to the front fog light connections? Thanks again!!

 

[Bobh82]

Top (left) slot has factory fog connector. The connector will match the factory front fog switch. Connect and slide back in.

The "S" is set to "no fogs" so you still need to go and have them use testbook to activate the harness before they will work.

Bob

 

[FIRE74]

Lights

Thanks Bob its a big help!!!