Search results

I have subtle noise when steering left coming from front driver side. it is not vibration just it feels like grinding noise. what should I check? 2002 d2 200K (km)

ok thanks. it is tight in there. if it is the heater core, how do i get to it? dash board needs to come out ?

hi I have a major leak between firewall and engine. what would that be? a burst coolant line? I do not have heat in the passenger cabin neither any guidances?

whole hub both sides?

Hi I need some diagnosis help. I think I have a problem with the speed sensor When I make a right/left turn, the 3 amigos come on. I know the ABS/TC are working because when I turn them off with abs amigo tool, TC kicks in but after a 10 to 15 mn drive and a turn, they come back on Is it...

Hi, Has anyone replaced the Serp belt on D2 without taking the fan off. Rave says to take the Fan off. Anyone knows if the new belt can slip around the fan ? any pulley tight spots? Thinking to use the goodyear Gatorback Belt 4070923. any feedback on this belt ?

Thanks for all your help. it is a live and learn. it ended up being the alternator hooked a regular battery charger and the truck started. lesson learned : power do not always work when battery 100% dead on another note: I like them tight and dirty

Hi My battery light came on , then M & S started flashing. I pulled over then truck died it wont start again? I hooked a power pack on and there is not light anywhere on the Dash. Where do i start to check this. I am thinking it is alternator but car wont start with a Power pack ? D2 2002 4L

Used D2 blower fan assembly for sale $250. Sold as is it was changed because of diagnosis mistake

how much for rear bumper ?

Hi Looking to rent or borrow ABS amigo tool in Toronto or southern Ontario. anyone had one or knows where to buy them in TO. Quick stop gap measure until i order my own unit. thanks

any idea on this?

thanks i think i have a different issue. not sure if it is the the resistor pack or the switch the fan does not come on in all settings even in HI does this mean it is the switch?

Hi My blower fan is not working. i checked the voltage at the connector and it is 11.9 to 13.15 depending on setting. the blower still does not work when I popped a new one in. what else can i check ? all fuse are ok. 13.15V @ Fuse 7 13.15V @ the motor connectors 13.15V @ at the Resistor Pack...

Hi Anyone knows where to get the best price on D2 Fan blower. is there an aftermarket options like Napa, ... the Motor is dead I think it needs replacing. I am getting between 11.7 and 13.7 V at the motor connector bit wont run. Hooked directly to battery , still does not run. just quick...

When I grease the rear drive shaft U-joint, grease comes out only on one side of the 4 arms. The 3 others seem jammed and would not seep grease. Do I have to replace the U joint ? is there a way to force the burned grease off the endings? Thanks

Hi Lately with the cold snap, the headlights take a long time to turn on after they are switched. It can be as long as 3 mn to turn on after I hear the relay click. what could it be ?

Anyone knows the best deal place to get tires in Buffalo or Rochester ? looking for a Grabber AT2 set.

Solved. The resistor connectors had problems passing the Power back to the relay. The resistor is an aluminum-like plate behind the left head light it has a warning sign : "Too hot" incase you are looking for it.

Ok i did some voltmeter testing. I found that: 1- Power reaches Fuse 5 from Fuse 13 (engine compartment) 2- No Power between Fuse 5 and the Fuse 3 and 22 (the headlight fuses) 3- When i switch the lights on, they work (power exist between F3/F22 and the headlights) Do you know if the relay...