Search results

I have a complete hard top with mounting hardware for sale. This came off of a 94 NAS 90 and has been in storage for the last 6 years. There is some very slight damage on the rear passenger corner, but otherwise the top is in good condition. Top is located in Louisville Kentucky and will be...

OK, can't seem to get this setup working. I purchased I mallory unilite distributor and a mallory E Series Coil 30451. Wiring is pretty straight forward, the distributor harness gets a solid engine ground, then one wire to the neg terminal of the coil, and another to the pos terminal of the...

My 1995 automatic has been been having issues the last few summers, where if you are driving in the city with the AC on, it would slowly begin overheating. If you turn the AC off, or are driving on the interstate all was ok. Now it starting to get a little worse, overheating in city driving...

I realized yesterday that my the handset cable was sliced so the unit is dead. Wanted to see if anybody had one laying around to sell. I already have the power piece installed, just really need the handset.

What options are out there for rear seat covers in a D1. Only one I can find is the Wet Okole, but would prefer something more reasonably priced, and all one color. Any Ideas? Also I mean second row bench, not the third row fold up seats.

I had truck run into the back of my 95 D1 which resulted in the insurance company paying to have the rear door replaced. I didn't notice it for a couple of months afterwards that the rear wiper was no longer working. I ordered a new used one thinking the old one was bad somehow. But now I...

I need some wheel spacers, I only need two, but message me if you have a full set, I may be willing to take them all.

I have six tornado style wheels off of a DII. They are painted black in the center, and four have tires but 3 are 255 and one is 265, the tires are well used. One of the wheels is chipped along the lip, it still holds air, but I only used it as a spare, which is why I have six. I also have a...

I need to replace some things in the engine compartment of my 1995 Discovery. Underneath the charcoal canister and jack there are foam pads that are adhesive on the bottom. Also there are body colored sticker dots about the size of half-dollars that are used to cover holes in the engine...

Have the heads off a 1995 DI anyone know a good place to take them and have them redone in Louisville KY?

I have a DII Kalahari style (also referred to as Gulf Spec) front bumper, factory DII front brush guard and a hidden winch mount tray for sale from DAP-inc. These items are going to be local pick up only from Louisville Kentucky and I will be leaving town for two months at the end of November...

We are restoring the old family farmstead and once the work is finished on the house and barns I am wanting to plant lots of fruits and vegetables there on the grounds. I have suitable land and terrain for most all varieties, however now I am trying to figure out exactly which varieties of each...

Does anyone know if the the Distributor Rebuild Kit RTC5971 comes with the springs necessary to repair the mechanical advance in the distributor? -Stuart

Does anyone know, what the correct fitting types are for the fuel line connectors at the top of the fuel pump on a 1995 disco1? I was thinking they were 1/8" NPT, is that correct? The connector to the tank side of the fuel filter is siezed, so I was going to replace that section of line, but I...

Ok I have a few things happening on a 1995 D1 and wanted to see if anyone had any suggestions. Issue 1) - Rough idle at operating temp. I can start the truck it runs just fine until the engine temp gets up to normal, then the idle is a little rough bouncing a few hundred rpm. If you stay in...

I have a 2000 Discovery II slver in color with grey leathr interior,~125,000 miles. I am seeing if anyone is interested in the truck as is, Curret setup: 265/75 BFG/AT Full 2" OME lift OME steering damper CDL linkage from Disco1 Rhino lines underneath stock carpet front seat covers rear seat...

Never Used for DiscoII Expediton Exchange Extended Stainless brake lines front and rear - $100 for both Extended ABS sensor wires front and rear - $50

Anyone got a front bumper for a DII?? In Zambezi would be best, but I will take whatever I can get. Thanks -Stuart

Does anyone have one of these preferably in gray? I need the kind with the raised edges that would hold water, not the black mats that lay flat. Thanks -Stuart

I need a set of seat covers for a DII, prefer the genuine and need gray, anybody got any of those around? Need front, but also would like back to match. -Stuart