Search results

Does anyone know what the pressure should be if testing the brake booster for vacuum leaks?

Just saw this and thought this might be intersting to follow. Tata super cheap vehicle to the Rover line. http://news.yahoo.com/s/nm/20080910/india_nm/india354107

I have been experiencing a bind & jerk somewhere in my drivetrain. It happens when I accelerate from a dead stop and sometimes on slow up slope conditions. I have a truetrac up front and a detroit locker in the rear. LT230 transfer case. I have checked for any brake or parking brake...

Do anyone use a Hayden 2772 clutch fan on their V-belt engine? I saw a listing for this as being heavy duty and was wondering if it would pull more air than an OEM type. In other posts here, I have seen alternative clutch fans for the seprentine models but nothing for a v-belt.

What is the correct operating temperature for the Rover? I have added a manual gauge and am interested if I am operating in the right realm. I know that there are a lot of variables (ie. ambient temperature, load, etc.) but there should be some kind of guidelines.

Where is a good place to install a temperature sensor, thus getting Lucas out of the equation?

I recently installed a Mallory Unilite in my 88RRC. The bottom end is a new 4.6 with my old heads rebuilt. I am experiencing detonation under load and acceleration conditions. I am using premium fuel and have timing set to 6degBTDC. Should I retard a couple more degrees or should I reduce...

Does anyone have any ideas, experience on replacing RRC seats with after-market ones?