Search results

  1. O

    OME Spring Identification

    This link maybe of some help. http://members.shaw.ca/jbarge/springinfo.html
  2. O

    Spring specifications

    Sure can.......try this http://members.shaw.ca/jbarge/springinfo.html
  3. O

    OBD reader can't/won't read codes?

    Fogot to say I have the circuit digram of the OBD2 connector, in PDF format, if anyone wants it. Steve
  4. O

    OBD reader can't/won't read codes?

    Pin 16 on the OBD2 connector carries voltage, wire colour is RW, wire goes to Satellite Fuse box B2, fuse F3, battery voltage is carried constantly. Hope this helps :)
  5. O

    OBD reader can't/won't read codes?

    Yep.....got the same problem on a late 1996 D1. Spent hours checking the OBD2 connector and traced out every single wire back from the connector. Checked for continuity, checked all connectors in between. Gave up in the end, have been able to connect an OBD2 scanner.
  6. O

    Front Cover Tips

    Ummm...I have an October 1996 with a distributor.
  7. O

    One Bank Running Rich

    Hi Chris, Yes I did, both banks. Thought I'd run it for another 500 miles or so and check them again. I was wondering if its connected to the fuel pressure problem I have. When I turn the ignition on the pressure comes up to 20lb per square inch from zero, start the engine and it comes up to...
  8. O

    One Bank Running Rich

    Took the plugs out of my D1 at the weekend, four plugs in one bank were ok, nice tan colour, no deposits. The four plugs in the other bank had heavy carbon build up, dry and very sooty. What would cause one bank to run rich? Where do i start looking? Got 95,000km on the clock. Thanks Steve
  9. O

    Electric Fan - 2 x 12 inch or 1 x 16 inch?

    Hi All, Fan clutch needs changing, and I thought it a good opportunity to fit an electric fan. While the Flex a Lite 210R would be my choice, they are not available here in New Zealand :( I can get my hands on 2 x 12 inch Derale Tornado's or a WYSCO 16 inch. Whats your view on the twin v...
  10. O

    Low and Falling Fuel Pressure

    Hi Everyone, Got a 1996 with 90,000 kms on the clock, fitted a fuel pressure gauge last night, and have a problem with the fuel presure. With the ignition on the pressure is 20 psi. Turn it off and slowly the pressure drops to zero, within a minute. Start up the engine and the pressure is 36...
  11. O

    Ok, who has named thier Disco

    My wife....... calls it the Beast
  12. O

    Rear standard spring colour coding? D1 1990

    Ok...try this one http://www.landroverclub.net/Club/HTML/Spring_rates.html
  13. O

    Rear standard spring colour coding? D1 1990

    Check this link out...http://members.shaw.ca/jbarge/springinfo.html
  14. O

    What year has the ERR7282G clamp?

    The fix came out in Dec 1997.
  15. O

    turn signal fuse

    Are your stop lights working?...if they are, then its not the fuse, they share the same circuit. The fuse is behind the trim panel, under the steering column, main fuse panel , fuse 1.
  16. O

    No voltage to cruise control pump

    The black thingy is the Brake Switch Vent Valve. Get down in the foot well with a torch, and look up at the brake pedal, you'll see the brake light stop switch and just below it a square hole. Thats where the vent vave fits into. The wires on the two pin connector that fits into the valve are...
  17. O

    New Ignition Coil - Won't Start -1996 D1

    Fitted a new MSD 2 Coil over the weekend, started her up and it ran fine. Put the tools away, cleaned up, and started it again, this time it started, ran rough for a few seconds and then slowly died. Now it refuses to start at all. Double checked the conections, all ok there, put the old coil...
Top Bottom