Yeah - it is slightly more complicated though. The aftermarket sensor has a resistance/voltage curve that correlates to pressure. The clock display reads in resistance (from what it thinks is a thermistor) but instead the Arduino drives a chip that provides an artificial resistance correlated to...
If you want to read oil pressure live you would need to install a pressure sensor either in one of the existing holes near the oil pump, or install a "sandwich" port between the pump cover and the oil filter. From there you run the wire coming from the sensor to a host of aftermarket gauge...
No need to flip the A/C switch on for this mod. Basically by grounding the 87 side of K109 you are mimicing the signal that the consenser fans would get if the A/C switch was on.
I had one of these carling switch mounts already...
Would also check the charcoal canister/vapor management system. In my truck, one of the lines to the vapor management system broke off at the filler neck and pinched itself closed . Since there wasn't a venting system, the tank would heat up/pressurize with use and fuel vapor would come into the...
When you say binding do you mean
1) That you're feeling resistance when rolling/turning; or
2) That you're hearing some kind of sound
Also does this happen in neutral - and any particular times (e.g. accel, decel, uphill, etc)?
In the past my driveline issues were related to the parking...
You might know this already, but installing a PTO on a Discovery will take some bodywork to achieve. Here is a post I wrote up on another forum. I have a manual trans but I'm guessing position of the LT230 is the same/nearly the same for the autobox since the rear prop shafts don't change...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.