Search results

Hi all, Does anyone have/use the iCarsoft i930 with the 1996-1999 Disco 1's. If so, does it actually work for the ABS, SRS and LR specific codes? Thanks. M.

I picked up a 96 D1 ECU that the prev owner had trashed the ecu trying to chip it. So I'm looking for one. I think it's p/n ERR6759, as the trashed one didn't come with the label. Thanks, M.

Hi All, I'm going to do the upper end on my 1996 Disco1 4.0 and am wondering what others are using for replacement camshafts. Some offroad, but lots of highway driving. I was looking at the Crower site and they have quite a few options...

For the past two months I've had a distinct whine coming from the transmission of my 96 D1. It's not overly loud, quite high pitched, and happens only while moving and not coasting, stopped or in park. e.g. If I let off the gas the whine goes away. A slight pressure on the gas pedal and...

Yup. Sorry. Searched all the old discussions but couldn't find a solution. <!--[if gte mso 9]><xml> <o:OfficeDocumentSettings> <o:AllowPNG/> </o:OfficeDocumentSettings> </xml><![endif]--> My 96 D1 is throwing one code - P1193 - O2 Downstream Heater - Inferred Open Circuit Fault (one...

Hi, I just picked up a 160amp alternator off eBay. Before I mount it, I was looking at the wiring diagram for my truck. Between the battery and Alternator there is a 100amp fusible link. Should I be upgrading that to a 160amp fuse, or should I disconnect the alternator from the panel and...

I just picked up a CB unit and am confused with all the rhetoric re. types of and locations to mount the antenna. Any suggestions re type, length, etc. to maximize the transmit/receive range would be appreciated. Thanks. M.

So I was on vacation this past week in my till now, trusty D1. She only has a bit under 100k miles on her. Although we were only doing 80-90kph (50-60mph) fairly steady on back country highways, intermittently the temp would suddenly rise almost to the top of the "OK" scale. I would put on...

Hi all. Quick question - do you have to remove the coil pack to get at the connections when replacing the front O2 sensors? Thx. M.

Hi all, I'm adding a TerraFirma return to center stabilizer to my D1 and building my own brackets. From what I've found some kits and people mount then in front of the drag link/steering shaft/(whatever it's called), and some behind it. I also see a large variation of pin location on the...