Search results

Which is preferred or better for use on the transfer case or which would hold up longer? I know it comes with the liquid seal but thought the gasket may work better. Thanks

Anyone ever purchased a vehicle using Liberty Trust LLP as a third party?

Is this from an 04 or can anyone tell by looking? I think it is from looking at the picture.

Ladder is in great shape. I decided not to install it. $80 plus shipping. Hardware included minus rivnuts. Had two spots where the finish was cracked, but I pulled the cracked coating off around the spots and sprayed it with paint to keep it from rusting. One spot is up top and the other is on...

Will the rear upper lamp guards from an 03-04 fit a 99-02? I have talked to rover north and the local dealer and the said no. I don't see why they would not fit. Thanks Heath

How can I tell an SD from an NWP other than by welds? What is a good price for a used SD in good shape? Thanks

http://www.youtube.com/watch?v=YcOZJo2mlJs

What is an estimated price to ship a rack (400 miles) and Who could I go with to ship it. Thanks

Would anyone have any ideas of new and emerging trends in federal jurisdiction? Thanks Heath

I went to roll my window down this morning and I heard a pop and then what sounded like a wrench dropping on the ground. I can pull my window up and down by hand and the window switch does not move the window at all. Does anybody have an idea of what broke or came loose? :confused: Thanks Heath

Does anybody know where I can get one of these t-shirts? :D

What is the most inexpensive but reliable way to ship something weighing around 150-200 pounds?

I was sure from prior post that a 2004 transfer case would fit a 2002 without any modifications. I called to order a transfer case and the guy told me it would not fit. I thought it would fit without any modifications, but before I spend any money I want to make sure it will fit without any changes.

What is a good price to pay for a used t-case with 10-15k miles and CDL nipple?

I really need someones help. I have replaced the inspection plate seal and the two seals above it ( don't know what they are called) I have also checked the output seals and they seem to be fine. So were do you think this thing could still be leaking from?

I have the rear cover plate off of my transfer case and was wondering what is needed to get the spacer behind it off so I can reseal it. Does it have come sort of clip ring that is holding it on or what??

Just thought I would post this. An open ride will be held at gray rock Feb. 3,4,5. Camping is avaliable if needed. I have not been so I dont' know anything about it. www.grayrockorv.com http://www.caos4x4.com/cmbs/index.php?topic=3546.0. I am going to try and make it if possible.

Anyone know how to make one and what materials are required?

I was reading on another site and a J**P guy was talking about buying a land rover so his family could wheel. I replied and told him some websites to check out, basically just trying to help him out in his information search. He later replied back with this crap about no rover around would run...

Would anyone happen to know where some good public trials are in North Alabama?