Search results

http://www.snowaddiction.org/2013/11/you-will-not-believe-how-these-russians-get-this-car-out-of-a-frozen-lake.html

Looking for a set of cross rails, shipped to 34744.

I'm anal so I numbered the bolts when I removed them - so I'm 100% sure they are going back in the same holes. Just as well because there are 3 different lengths! One bolt on the driver's side (centre bolt holding the bracket for an electrical connector) stops about 1/8" short. I checked the...

I have a set of D2 rims off a 2002 for sale, I have a buyer interested for his 1996 RR. Will it fit? Sorry for the dumb question, I did some searching but can't seem to find the answer.... He has some really nice 22s if anyone is interested :rofl:

D2 2004, engine is out. Need to get tranny out of P to pull the shifter, center console and all the crap to get at the xcase shifter and CDL linkage. Battery is dead too. Btw this is not a driver, it's a parts truck. I did the obvious: hooked up a battery for some juice, turned the key, hit the...

I'm getting conflicting torque values from rave for the track rod and drag link: Page 06-15: Track rod and drag link 80 Nm (59 lbf.ft) Page 60-31 point 6: Fit track rod and drag link nuts and tighten to 80 Nm (59 lbf.ft). Page 60-38 point 7: Fit track rod to steering knuckle and secure with...

How much air would you expect to leak from reman heads? Am I unreasonable to think 0? I did a simple test by clamping a 1/4 steel plate and gasket material over the combustion chamber, then attached a hose to the spark plug hole and gave it 40psi compressed air. I filled the ports with water and...

I installed a new cam and new lifters and a bunch of other new parts less than 3000 miles ago. I started getting intermittent 0306 errors and decided to dig in and investigate. Well the #6 intake lobe has been wiped and the #1 intake lobe is not far behind. The rest of the lobes look good, but...

Set of 5 rims 16x8. No dings or dents, light surface marks on 2 of them. No tires, rims only. Located in ZIP 34744. $250 for the set. https://picasaweb.google.com/lh/photo/4fVydTm_jCXYFV6R-fU4FtshbEMSmn32ChmF_JZyERs?feat=directlink

What's the secret to removing the pillar trim without breaking the piece of crap? :banghead: I destroyed mine being impatient and have a replacement sitting on a donor vehicle. The trick is to unclip the metal clips from the body, but they are a bitch to get off. Do I need to buy the land rover...

I have this heat shield left over for a 2003 D2, where does it go? I suspect on the left of the engine somewhere but have not found a good spot for it.

2003 D2 out side VIN range for oil pump failure. Background: slipped liner, got a 2002 RR 4.6 short block with 80K, stripped it and had it cleaned and checked out and deglazed. Put in new main and rod bearings, rings, camshaft, timing chain and gears, lifters, push rods, rockers, rocker shafts...