Great looking heads:)
I did the math and for me to have my heads skimmed and gas-flowed here in South Africa, it would be cheaper to fly a complete assembled set in from Turner Engineering in the UK.
Strange as it sounds, it's true.
Get a few extra cups.......
If they start goinig in at an angle , they are difficult to realign without damaging them.
Good luck.
Done it once and never again.
PS would help if you can get hold of a precision engineering vice as it will ensure that you press the cups in square.
I run with OME HD springs and find the ride great. As long as the rooftop tent stays on the truck, you'll have a good ride.
HD springs and no load tends to be a bit harsh
Check the tcase and outer pinion bearings. Might be easier if you just dropped both front and rear prop shafts and check for play on the flanges.
Check both Panard rod bushes.
Check all ball joints on steering
Yea, but did you have a close look at that cable..................
It's bloody audio cable. Not shielded to handle upto 400 AMPS
I had a look at my wiring this morning and yes you are correct that my warn has a 2 guage power cable, but it's top quality shit ;) Standard cabling from Warn themselves
Hey, don't piss-off the brains trust here. PT, Chapman and co. deal with these issues all day in their jobs and know what the hell they are talking about.
You made an idiotic remark that 2K idle at start-up was "normal". Deal with it. Wipe the egg off your face and learn something.
Back to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.