Recent content by psykokid

Robert, Thanks for taking the time to figure this out. It's a great resource to the community. Back when you first released it I wasn't able to get the windows version to work on my PC, but it worked fine with the OBDLink LX on my wife's macbook. That was good as I had done a bunch of work and...

Long story short just realized I've got a leak in one of my rear ac lines. No one local has it and I'm leaving for a trip on Saturday and really need A/C. Daytime temps through the central valley of CA is supposed to be in the upper 90's so 4 windows down @ 65 wont cut it. If i can find out what...

My dad has one on his spare for his scout. He said when he was younger they referred to tires with that tread pattern as "howlers" because you could hear someone coming a mile away on pavement..

Elais - you still have the cruise control module sitting around?

Well, after getting under the truck and pulling the stock fuel tank cradle I put the bracket in place and It will clear with a little notching on the plate itself and the bracket. Fit will be tight but it will work.

Looks like it might. Before I'd go dropping money on a coil pack though I'd move the suspect coil pack to another position where it's firing another cylinder and see if the misfire follows. I had a misfire on cylinder 1 and swapped the coil packs around on the frame and the misfire stayed at...

Asfir is still around, and has been around for about 5 years. It's that just AOTech is no longer the US distributor from what I can tell. AOTech had a list of stuff on their facebook page that they were blowing out for cheap, some rover stuff and lots of jeep and other domestic stuff too. I...

I've got a set of disco 1 spare steel wheels that I was running on my truck that I would like to get rid of. Dont need to have 3 sets of wheels kicking about. They have a set of old bfg km's on them in 245/75/r16, two are ok for trail spares to get you home, two don't hold air.. Looking to get...

Yes, I did get it from Eitan. FWIW they were blowing out thier stock on Asfir stuff since they are no longer the NA distributor for them. Not sure what he can do. I did shoot him off an email though. I'll update when/if I find out anything..

Anyone installed one of these? Picked up one pretty cheap, but was laying under the truck the other night and I dont think the rear mount will fit without some modification due to the NAS style rear hitch. IIRC the plate was made for a D1 300 TDI which has the rear hitch which is a bolt on...

Same thing happened to a friend, same solution. Replace the pump housing with the sensor in it.

Well, I live pretty close to the Temple City address.. I can roll by and see if i can put eyes on his truck.. I think he was trying to sell his truck on expo around this time last year. Well, if it was a D2 that is...

no thanks.. :ack:

Just changed up my wheels and tires so I have a set of disco 1 spare steel wheels that I was running. They have some old bfg km's on them in lt245/75R16 that have a little bit of life left on then. Looking to get 100 for the set picked up near Pasadena, CA. Not looking to ship or dismount the...

You can get the tool pretty cheap at autozone to clamp the oetiker style clamps : http://www.autozone.com/autozone/accessories/OEM-CV-joint-boot-pliers/_/N-26na?itemIdentifier=141501_0_0_