Recent content by disco_drum

I have a set. I can send them to you. Send me a direct message.

I did, just hadn't heard back yet. But I got a response from them now.

I am rebuilding my rear driveshaft. I need to know what centering ball to order for the double cardon joint. Does anyone know the part number?

I have one of these exact wheels I'll sell you. Check your private messages!

I'll take it!

Nanocom...and yes I have cleared. Code came back.

I have code P0455. I have replaced purge valve, gas cap, inspected all the lines, and smoke tested the system and can't find anything. Any ideas? I wouldn't care, but I have to pass emissions here in Atlanta.

yes. I need it gone!

BUMP. Still available. And price change to INCLUDE shipping.

They are on a D2, but will work just fine on a D1. Not sure on age, but I think they are 'older' RTE springs. Gray in color. No rust and seem to be very lightly used.

I have a complete setup from a parts truck. The springs are front RR 4-1 and rear RR 1-2. The shocks are typical OME shocks in good shape. $300 shipped.

PMd you

Let me know what you need. Parting out 2001 Disco. Engine runs, but the ECU and wire harnesses are no good. Rear steel bumper (basically new)- SOLD 265/75r16 Nitto Ridge Grapplers (less than 100 miles on them) on Rover alloys - $1000 Interior is in good shape, if you need any bits make an...

I figured it out today. i performed some electrical wizardry after much studying in the RAVE manual. On connecter 4 (C0637) on the ECM i switch pin 12 to pin 14 and also switch pin 31 to pin 9. This got the correct signals to my fuel tank pressure sensor. When I did the swap I kept all the...

I am getting p0452 (fuel tank pressure sensor) fault on my D2. I cannot for the life of me figure our why. I tried installing a spare fuel pump I have (sensor is built into pump) and still getting the code. Nanocom reads as follows: P0452 occurs during drive cylce c signal too high I can clear...