I just swapped out all of my rotors and pads on my DII (thanks for the info Nathan). After I finished the struggled to complete one rotor and pad swap, thankfully one of my friends came by with an electric impact wrench that shaved off 40 min per swap compared to doing it all by hand.
Anyways, just before the board swapped over there was a posting on what type/size of tool correctly fit the screw that holds the rotor to the hub. Does anyone recall what it was? My largest Philips didn't fit so I was having troubles with removing the screw(s) and tearing them up which I want to avoid the next time I have to do a swap.
Anyways, just before the board swapped over there was a posting on what type/size of tool correctly fit the screw that holds the rotor to the hub. Does anyone recall what it was? My largest Philips didn't fit so I was having troubles with removing the screw(s) and tearing them up which I want to avoid the next time I have to do a swap.